ELF > `@ @ , @ 8 @ @ @ @ @ @ @ @ @ @ ` ` ` ` @ @ D D Ptd @ @ 4 4 Qtd /lib64/ld-linux-x86-64.so.2 GNU GNU #-uImAfD0="M ) 9 V ! s > 7 E & k d ` ` ~ P ` tf~ tfZ7 ii
ti ui ` P ` ` ` ` ` ` ` ` ` ` ` `
` ` `
( ` 0 ` 8 ` H; H5R %T @ %R h %J h %B h %: h %2 h %* h %" h % h p% h `%
h P% h
@% h 0% h % h
% h 1I^HHPTIP@ H`@ H
@ 7HH HtHÐUHSH= uK ` H H ` HHH9s$f D HH} ` Ho H9r[ H[fff. H= UHt Ht ` ÐHa H= 1&f D AWAVAUATIHUSHH(DA~yAD$ tkD$A 1L|$ @ ACIHE9~.D$CH|$ LD$RA$D- A9H([]A\A]A^A_1Ll$Lt$AH\$Hl$ع Ld$L|$HxdH%( HD$81HIHAE L~@ L?7 InHKH H|$ H_Au 1A 11>@ 1Ҿ +Ab T@ L; X@ L q@ L9 @ Lt @ L_ @ LJ H⾃ D$ i H= 0@ 1 f D I^@ H1҅tI@ H t3 @ H t @ H 1AT$ I~
1ÉD$ | D H⾃ D$ ) H= 1Iٺ@ 1HT$8dH3%( H\$HHl$PLd$XLl$`Lt$hL|$pHxfH= @ 1 H⾃ D$ H=Z H\@ 1vfH⾃ D$ I H= IH麨@ 13#f D H⾃ D$ ; H= IH麐@ 1f D I~
10I~ Hú
1 \$ fD$41 D H⾃ D$ H=R IH @ 1k[f D H=) @ 1H8H= (@ 1& ,H= DH@ 11 H= x@ 1 Y8H={ IHP@ 1 %8H=G H@ 1s yH=" L@ 1N1 M8H= IIٺX@ 1 8KH= IH @ 1 ^8H= IH@ 1 *8H=L IHp@ 1u {H=$ *@ 1S1 Rfffff. Hl$Ld$H-{ L%t Ll$Lt$L|$H\$H8L)AIHIHt 1 @ LLDAHH9rH\$Hl$Ld$Ll$ Lt$(L|$0H8ÐUHSHH Ht ` D HHHuH[ÐHH Expecting argc to be 3-5, inclusive. Was: %d
ERROR: if_name must be 15 characters or less.
WARNING: Could not open /proc/net/vlan/config. Maybe you need to load the 8021q module, or maybe you are not using PROCFS??
FATAL: Couldn't open a socket..go figure!
ERROR: trying to add VLAN #%u to IF -:%s:- error: %s
Added VLAN with VID == %u to IF -:%s:-
WARNING: VLAN 1 does not work with many switches,
consider another number if you have problems.
ERROR: trying to remove VLAN -:%s:- error: %s
ERROR: trying to set egress map on device -:%s:- error: %s
Set egress mapping on device -:%s:- Should be visible in /proc/net/vlan/%s
ERROR: trying to set ingress map on device -:%s:- error: %s
Set ingress mapping on device -:%s:- Should be visible in /proc/net/vlan/%s
ERROR: trying to set flag on device -:%s:- error: %s
Set flag on device -:%s:- Should be visible in /proc/net/vlan/%s
ERROR: trying to set name type for VLAN subsystem, error: %s
Set name-type for VLAN subsystem. Should be visible in /proc/net/vlan/config
Usage: add [interface-name] [vlan_id]
rem [vlan-name]
set_flag [interface-name] [flag-num] [0 | 1]
set_egress_map [vlan-name] [skb_priority] [vlan_qos]
set_ingress_map [vlan-name] [skb_priority] [vlan_qos]
set_name_type [name-type]
* The [interface-name] is the name of the ethernet card that hosts
the VLAN you are talking about.
* The vlan_id is the identifier (0-4095) of the VLAN you are operating on.
* skb_priority is the priority in the socket buffer (sk_buff).
* vlan_qos is the 3 bit priority in the VLAN header
* name-type: VLAN_PLUS_VID (vlan0005), VLAN_PLUS_VID_NO_PAD (vlan5),
DEV_PLUS_VID (eth0.0005), DEV_PLUS_VID_NO_PAD (eth0.5)
* bind-type: PER_DEVICE # Allows vlan 5 on eth0 and eth1 to be unique.
PER_KERNEL # Forces vlan 5 to be unique across all devices.
* FLAGS: 1 REORDER_HDR When this is set, the VLAN device will move the
ethernet header around to make it look exactly like a real
ethernet device. This may help programs such as DHCPd which
read the raw ethernet packet and make assumptions about the
location of bytes. If you don't need it, don't turn it on, because
there will be at least a small performance degradation. Default
is OFF.
set_name_type VLAN_PLUS_VID VLAN_PLUS_VID_NO_PAD DEV_PLUS_VID DEV_PLUS_VID_NO_PAD Invalid name type.
/proc/net/vlan/config add rem Removed VLAN -:%s:-
set_egress_map set_ingress_map set_flag Unknown command -:%s:-
@ ;4 P h P zR x 8 L 4 @ BBB B(CD0A8CD`x
8C0A(B BBBA , > M]f]
C $ Q_@FR H@
(@ o `@ x ` @
` h @ @ H o X@ o o 0@ o P@ o ( o x ` o ( ` v@ -S; .S; P 0S; Y#S; !S; (S; l#S; /S; .S; 0!S; 0(0S; m#S; -S; XS; @XS; __gmon_start__ libc.so.6 socket exit __stack_chk_fail strtol strlen __errno_location __fprintf_chk stdout strtoul strcasecmp stderr ioctl close open __strcpy_chk strerror __libc_start_main GLIBC_2.4 GLIBC_2.3.4 GLIBC_2.2.5 /lib64/ld-linux-x86-64.so.2 ` % M(S; ` % (S; 0XS; 8XS; @XS; `XS; xXS; pXS; ` ` xXS; XS; XS; P ` XS; PXS; `XS; XS; XS; % M(S; 0XS; % @p(S; S; 'S; S; 'S; S; 'S; S; 'S; S; 'S; S; 'S; vconfig.debug gf ELF > `@ @ P @ 8 @ @ @ @ @ @ @ @ @ @ ` ` T ` ` @ @ D D Ptd @ @ 4 4 Qtd @ @ ! <@ < $ 4 o `@ ` ( > @ F P@ P N o 0@ 0 & [ o X@ X @ j @ H t @ h ~ H@ H y `@ ` `@ ` (@ ( 8@ 8
@ 4 @ ` ` ` ` ` ` @ ` @ P ` D ( D X .shstrtab .interp .note.ABI-tag .note.gnu.build-id .gnu.hash .dynsym .dynstr .gnu.version .gnu.version_r .rela.dyn .rela.plt .init .text .fini .rodata .eh_frame_hdr .eh_frame .ctors .dtors .jcr .dynamic .got .got.plt .data .bss .gnu_debuglink .dynbss .gnu.liblist .gnu.conflict .gnu.prelink_undo @ @ ! <@ < $ 4 o `@ ` ( > @ o P@ P ( N o 0@ 0 & [ o X@ X @ j @ H t @ h ~ H@ H y `@ ` `@ ` (@ ( 8@ 8
@ 4 @ ` ` ` ` ` ` @ ` @ P ` P h ` h F x ` x x ` x ( " " x+ )